Downloads for LLEAP - Laerdal Learning Application

SimStart User Guide

3.4 MB - English
10.01.2020

Quick Guide WiFi setup

1.2 MB - English
24.06.2019

Session Viewer - User Guide

2.7 MB - Multilingual
10.07.2015

LLEAP License Agreement

0.2 MB
19.09.2023

Laerdal Learning Application (LLEAP) v. 8.7.3

1 356.5 MB
09.07.2025

Changes in this release: 

Security Improvements:

• This release includes security improvements for how the Instructor Application and Patient Monitor application communicate with simulators.

Compatibility changes

• SimMan Classic is no longer supported (Replaced by 3G family of simulators).
• SimBaby Classic is no longer supported (Replaced by SimBaby Tetherless in 2018) .

To continue using these simulators - do not upgrade and stay on LLEAP version 8.7.0

For an overview of supported simulators we refer to our support pages.

• LLEAP and SimPad supported simulators.

For an overview of compatible software we refer to our support pages.

• LLEAP and SimMan 3G compatibility matrix.
• LLEAP and SimPad compatibility matrix.
• LLEAP and Laerdal Patient Monitor Compatibility Guidelines.

Laerdal Patient Monitor v. 8.7.3

859.0 MB
09.07.2025

The Laerdal Patient Monitor software is compatible with LLEAP and SimPad.

Laerdal Patient Monitor software is included when you download LLEAP. This download allows you to install Laerdal Patient Monitor software without installing LLEAP on the same computer.

Changes in this version:

• CPR feedback is available on the LLEAP Defibrillator Monitor for QCPR simulators.

TLS 1.2 for SimMan 3G

73.5 MB
24.10.2022

TLS 1.2 patch for SimMan 3G using Windows 7

This is only applicable when TLS 1.2 is required, and can be installed on simulators using LLEAP 8.4.0 and later.

Procedyre to install:

1. Download file named ”SimMan 3G – TLS Setup 1.2.0.0.exe” and copy to a USB disk.
2. Start Simulator and connect to computer with Ethernet cable.
3. Remote into simulator.
4. Connect USB disk to simulators USB port (might have to remove WiFi adapter).
5. Copy file to E: disk on simulator.
6. Run the installer on simulator.
1. The simulator will now reboot and start installing.
2. This can take 10-15 minutes and the simulator may reboot several times during the installation.
7. When installation is done, the simulator will say "Simulator ready" and light above power button is then green a few seconds after.